destination node
英 [ˌdestɪˈneɪʃn nəʊd]
美 [ˌdestɪˈneɪʃn noʊd]
网络 目的结点; 目的节点; 目标节点; 到目的端; 端节点
双语例句
- In the direct methods, the final destination node is selected in one step.
直接方法在一个步骤中选择最终目标节点。 - The destination node may be in another document, in which case the subtree is copied between documents.
目标节点可以在另一个文档中，在这种情况下，在两个文档之间复制子树。 - This function takes the source node and copies it over as a child under the destination node.
此函数接受源节点，并将其作为子节点复制到目标节点下。 - You create a pure vector-based drawing here and render a line here from source node to destination node.
您创建了一个纯粹基于矢量的绘图，并且显示了一条从源节点到目标节点的连线。 - In the iterative methods, the final destination node is determined through several iteration steps.
迭代的方法通过几个迭代步骤确定最终目标节点。 - The destination node "{ 0}" has multiple source loop paths.
目标节点{0}具有多条源循环路径。 - The destination node "{ 0}" has { 1} data input ( s). The maximum number of possible data inputs to this node is { 2}.
目标节点{0}有{1}项数据输入。输入到该节点的最多数据数可能是{2}。 - With the new algorithm, a destination node could join the existing multicast tree by selecting the path whose cost was the least;
该算法中每个目的节点通过最小代价路径加入当前多播树； - Upon reaching the destination node the VLAN ID is removed from the packet by the adjacent switch and forwarded to the attached device.
到达目的地端所接的交换器时，这个含有VLAN编号的表头就会被拿掉，然后将封包传给目的地的设备。 - Then an efficient adaptive cooperative transmission scheme is proposed. First, the destination node determines whether or not relaying should be adopted and it sends the result to the relay node.
目的节点判断是否采用中继传输并将结果发送到中继节点，中继节点根据接收到的信息调整传输模式。 - In this paper, with the support of the QoS based initial route setup algorithms, based on resource sharing principles, QoS based destination node joining and leaving algorithms a.
其中，基于服务质量的多媒体通信目的节点加入与退出算法是关键组成部分。 - The other subsets are encrypted by intermediate nodes and sent to destination node.
其余的子集交给中间节点加密后发送到目的节点。 - This algorithm was based on MPH algorithm. It added the destination node to the tree step by step based on satisfying the delay constraint and increasing the multicast tree cost least.
该算法基于MPH算法的基本思想进行扩展，在满足时延限制条件和多播树代价增加最小的基础上，逐步将目的节点添加到多播树上。 - Methods The Node Location Routing Protocol ( NLRP) and its moving model have been proposed. The scalability overhead functions concerned with location upgrading and destination node searching have been established.
方法运用所提出的节点位置路由协议（NLRP，NodeLocationRoutingProtocol）和节点移动性分析模型，推导了与位置更新和目的节点搜索有关的开销函数。 - Destination node selects one or more paths from feasible paths set.
目的节点从收到的探测消息所代表的可行路由集中选择一条或多条路径。 - The former design only makes itself active node and can't configure its destination node.
原有的封装设计只能以自身为主动节点，发送的数据包不能对其目的节点进行配置。 - In the P2P network, the node which the fixed physical circuit connects to pass messages directly, but each other non-neighboring nodes must go through intermediate nodes communication, the message before delivered to the destination node must pass through one or more intermediate nodes.
在P2P网络中，有固定物理线路连接的节点可以直接传递消息，而彼此非临近的节点则需经过中间节点通信，消息在传递到目的节点之前要经过一个或者多个中间节点。 - This delivery process continues until the destination node receive the packet.
这种转发方式一直延续下去，直至目的节点接受到数据包。 - This corresponds to one-to-one communication in which one source sends the same message to only one destination node ( Point-to-Point). 2-Multicast operations.
这相当于一对一的通信，一个源节点只给一个目的节点发送了同样的信息（点对点）2–多目传播。 - The transmission from the source node to the destination node is done through a sequence of routers.
这种从源节点到目的节点的传输要经由一系列的路由器。 - The results showed that: routing the initiator can be a very good look to the destination node, and can be a good data transmission to the destination node; in single and multi beacon beacons circumstances, can achieve a good multi-hop transmission.
结果表明：路由发起者能很好的寻找到目的节点，且能很好的将数据信息传输到目的节点；在单信标和多信标的情况下，都能很好的实现多跳传输。 - The dual-hop relay system this thesis study only contains one source node and one destination node.
本文所研究的两跳中继系统均只有一个源节点和一个目的节点。 - The choice of routing path determines which node and how many nodes will be used when a data packet is sent from the source node to the destination node.
而路由路径的选择决定了分组数据从源节点到目的节点要经过哪些节点以及需要经过多少节点。 - A good routing protocol can quickly perceive routing and send packets to the destination node accurately.
一个好的路由协议可以迅速的感知路由，并准确的将数据包发送到目的节点。 - A routing protocol will be responsible for data transmission from source node to the destination node, including optimizing path between source node and destination node and forwarding data along the optimal path correctly.
路由协议负责将数据分组从源节点通过网络转发到目的节点，包括对源节点和目的节点间的路径优化，以及如何将数据沿着优化路径正确转发。 - By predicting the destination node channel, each node can communicate with each other.
利用预算出的目标节点的工作信道进行节点之间的通信。 - The traditional network protocols often require a stable end-to-end path exists between the source node and the destination node.
传统无线网络路由协议往往要求源、目的节点间存在稳定的端到端路径。 - Focusing on the two-hop model in which two source nodes communicate with a destination node through several relay nodes, the BER and the spectral efficiency of NPS-CM are analyzed.
针对两个源节点通过多个中继节点和目的节点进行通信的两跳模型，分析了该方案的误比特性能和频谱效率。 - Then we calculate the total hops of the two conflict bursts after deflecting from current node to destination node.
然后，分别计算产生冲突的两个突发包，从当前节点到目的节点经过偏射后的总跳数。 - Reliable data transmission is the key problem in the design and application of wireless sensor network, and it determines the multi-hop step route path when the data packets transfer to destination node.
可靠数据传输是解决无线传感器网络设计和实现的关键问题，它决定了数据包传输到目的节点时使用的多跳步路由路径。